Auto Code Search - GE 25007 Manual De Instrucciones

Programming Your Remote, cont.

Auto Code Search

The Auto Code Search searches automatically
through the codes stored in this remote. Read all the
following steps prior to starting the auto code search
as you will need to be prepared to lock-in the proper
code when found.
1. Manually turn on the device you wish
2. Press and hold the SETUP button
setup
3. Press and release the desired device
tv
4. Point the remote at the device and
5. Place your finger on the #1 button so
1
6. When the device shuts off or begins
1
7. Point the remote at the device and
to control.
until the red indicator light stays on
(approximately 2 seconds) and then
release the button.
button on the remote (TV, CBL, DVR,
B-RAY, SAT, AMP, AUX 1, AUX 2) the
type of device you wish to control. The
red indicator will blink once and then
remain on.
press and release the POWER button
(for TV) or PLAY button (for DVD, VCR,
etc.) to start the search. The red
indicator will flash (approximately every
2 seconds) as the remote searches.
Note: The remote must be pointed
at the device for the duration of this
search.
you are prepared to lock-in the code.
playing, press the #1 button to lock-in
the code. The red indicator light will
turn off. Note: You have approximately
two seconds after the device shuts off or
begins playing to lock-in the code.
check to see if the remote operates the
device as desired. If it does, no further
programming is required for that
device. If it does not, return to step 2
and start the auto code search again.
8