Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HARDWARE NEEDED
31
1/4-20 X 3 1/4 Carriage Bolt
(Qty. 4)
1. Attach Wood Bottom Board (#15) to Caster Beam Assemblies (#8)
as shown in Figure 1. Turn Caster Beams as shown and attach
board with four Carriage Bolts (#31) and four Wing Nuts (#32).
Tighten Wing Nuts securely.
NOTE: Make sure logos are right side up and
facing the outside as shown.
Caster
with
8
Lock
32
1/4-20 Wing Nut
(Qty. 4)
31
15
32
ASSEMBLY TIP
READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!
Note: Support Plate (#43)
is on the inside of Caster
Rail (#8) as shown.
43
Figure
1
4
On the top of each page you will find a picture of the
Hardware Needed (to scale) along with the Quantity,
Key# and Description. You can lay the hardware on
the picture to identify and sort the hardware.
CAUTION:
31
8
32
Caster
with
Lock
Publicidad
Tabla de contenido
