Stiga T8521 Manual De Propietario página 9

29
1/4-20 X 2 3/4 Hex Head Bolt
(Qty. 2)
8. Secure U-support tube (#21) to Strut Tubes (#17) with two Screws (#5) as
shown in Figure 6. Align holes in U-support with holes in Strut Tubes and
thread screw (#5) into hole in Strut Tube (#17). Tighten screws all the way
but be careful not to over tighten as you could strip threads on screws.
9. Attach Linkages (#16) to Leg (#19) as shown in Figure 6. Pivot Leg (#19)
out from the table top and pivot both linkages (#16) up and align hole in
Linkage with hole in Leg (#19). Attach Linkage (#16) to Leg (#19) using
Hex Head Bolt (#29), Spacer (#37) and Locknut (#34). Spacer (#37) goes
between Linkage and Leg. Attach other Linkage to Leg the same way.
Tighten nuts securely.
10. With at least two adults, repeat Steps 7-9
for other table top assembly.
29
16
16
HARDWARE NEEDED
34
1/4-20 Locknut
(Qty. 2)
Figure
6
34
37
21
5
Note: Make sure
to install #5
17
screws
9
37
3/8" Long Spacer
(Qty. 2)
DO NOT OPEN THE TABLE TO PLAYING
POSITION UNTIL BOTH TOPS ARE
INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS
BODILY INJURY OR PROPERTY DAMAGE.
34
17
5
#8 X 9/16
Screw
(Qty. 2)
19
29
37
Spacer goes between
Linkage Arm (#16) and
Leg (#19)
16
5 Note: Make sure
to install #5
screws