Tascam IF-DA64 Manual Del Usuario página 13

Device name
1
This is the name of the device that can have its settings
changed in the current Device View.
Change device name
2
Edit the device name.
Sampling frequency
3
Set the sampling frequency.
Bit depth
4
Set the bit depth.
Latency setting
5
Set the latency.
Use the following guidelines to change the latency setting.
Selectable
Connected network setup guideline
latency value
The transmission route from the trans-
250usec mitting device to the receiving device
passes through 1 gigabit switching hub.
The transmission route from the trans-
500usec mitting device to the receiving device
passes through 5 gigabit switching hubs.
The transmission route from the trans-
1msec mitting device to the receiving device
passes through 10 gigabit switching hubs.
The transmission speed of the transmitting
2msec
device is 100 Mbps.
Use this maximum selectable latency value
5msec
when creating a large-scale network.
CAUTION
•
Changing the name of a device will clear audio routing
settings. For this reason, we recommend changing device
names to names that are easy to identify before setting
audio routings.
•
Depending on network connection conditions, setting
the latency to a value higher than the guideline might be
necessary.
NOTE
•
Set the sampling rate and bit depth to the same values
as the other Dante devices that send and receive audio
signals. Also set the unit in which the IF-DA64 is installed
to the same values.
•
When using a switched (daisy chain) connection, which
does not use a switching hub, set the latency according to
the number of Dante devices that signals pass-through as
shown below.
8 Switched (daisy chain) connection example
Passes through 2 devices
Transmitting
1st device
e
device
Passes through 1 device
Transmitting
1st device
e
device
Receiving
2nd device
e e
device
Receiving
device
TASCAM IF-DA64
13