Updating The Firmware; Notes About Dante; Names And Functions Of Parts; Rear Panel - Tascam IF-DA64 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27

Updating the firmware

Two separate types of firmware can be updated to add functions
to this card.
Card firmware
Dante module firmware
Both firmware updates must be conducted separately.
Check the TEAC Global Site (http://teac-global.com/) for details
about the latest firmware and update procedures.

Notes about Dante

Dante is a transmission protocol developed by Audinate. Using
networks based on gigabit Ethernet standards, it enables multi-
channel (512 IN/512 OUT) transmission and high precision, for
example.
Check the Audinate website for details about Dante.
https://www.audinate.com/
This card includes a Dante module circuit board made by
Audinate.
See the following Audinate web page for information about
the open source components used by the Dante module
circuit board.
https://www.audinate.com/software-licensing

Names and functions of parts

This card has two RJ-45 connectors that support gigabit Ethernet.
Use LAN cables to connect these connectors to other devices that
support Dante or a Dante network.

Rear panel

PRIMARY connector
1
This is the main Dante transmission connector.
Use this to connect to a Dante network all the time.
SECONDARY connector
2
This is the secondary Dante transmission connector. The use
changes depending on the mode.
When in redundant mode, this connects to the secondary
Dante network.
7
TASCAM IF-DA64

Publicidad

Tabla de contenido
loading

Tabla de contenido