LG WF-T1011TP Manual Del Usuario página 27

C
onnecting Water Supply Hose
Before connecting the Water Supply Hose to the water tap, check the hose type and then
choose the correct instruction here under.
Note that the Water Supply Hose supplied may vary from country to country, Make sure
to connect the blue inlet hose to the COLD water tap, and the orange inlet hose to the
HOT water tap.
Connecting Water Supply Hose to water tap
Normal Type
1
Untighten the screw
Untighten the screw of the connector so that the
tap can be placed in the middle.
2
Fixing the connector to the tap
Push the upper connector up till the rubber
packing is in tight contact with the tap. Then
tighten the 4 screws.
3
Attach the water supply hose securely to the
connector
Push the water supply hose vertically upwards so
that the rubber seal within the hose can adhere
completely to the tap.
4
Fixing the connector to the water supply hose
Attach the water supply hose to the connector and
then tighten it by screwing it to the right.
5
Check the connection of water supply hose and the connector
After connecting the hose, open the tap to check
for any water leakage.
If the water leaks, close the tap and start again
from step 1
Attention
The washing machine is to be connected to the water mains using new hose-sets and old hose-sets should
not be reused.
(Normal tap without thread & screw type inlet hose.)
Rubber packing
screw
Connector
Connector
Water
Supply Hose
27