Parts Description; Before The First Use - Tristar ST-8910 Manual De Usuario

PartS deScriPtion

1. Steam cable
2. Power cord with plug
3. Base
4. Thermostat knob
5. Iron at-temperature light
6. Steam button
7. Soleplate
6
7
4 5
1
2
3

Before the firSt uSe

• Take the appliance and accessories out the box. Remove the
stickers, protective foil or plastic from the device.
• Put the power cable into the socket. (Note: Make sure the
voltage which is indicated on the device matches the local voltage
before connecting the device. Voltage 220V-240V 50Hz)
• Place your steam generator on a stable, horizontal heat-resistant surface.
• For the first use, use the iron on an old piece of fabric to ensure the
soleplate and water tank are completely clean.
• Never use the steam generator when water tank is empty, refill it
before use it again.
uSe
Your new Pro Steam Generator is an attended appliance, and as such
should not be left operating unattended. Always rest the iron on the Iron
Rest provided for your safety and convenience.
fiLLinG Your Pro SteaM Generator iron
Make sure the device is off and on a stable, flat surface, remove the water
tank from the base by pulling it from the front, fill the reservoir with clean
cold tap water until the maximum water level mark. Note that you do not
add more water. Never add other liquids to the water! The cable between
the steam iron and the base may be hot, this is normal. The jet of the
exhaust steam is very powerful, so make sure you do not focus on people,
pets or delicate items.
uSinG Your Pro SteaM Generator
Insert the plug into the wallsocket and hold the left button a few seconds, you
hear a soft tone and the display lights up like the following image, the standby
symbol flashes and the device starts with the warming. When the standby
symbol disappears and you hear a soft signal the system is ready for use.
Steam generator iron
EN
5