Orbegozo VT 2410 Manual De Instrucciones página 11

VT 2410
TECHNICAL CHARACTERISTICS
INSTALLATION INSTRUCTIONS
Before using your wine refrigerator
• Remove the exterior and interior packing
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded. To
level your appliance, adjust the front legs at the bottom of the appliance.
• Keep wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold or hot ambient temperatures may also cause the appliances not to perform properly.
• Not designed for placement in adage or basement.
• The appliance is for indoor use only.
• Caution: Please keep the appliance away from substance, which can cause ignition.
ELECTRICAL CONNECTION
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have
it replaced by an authorized Products service center.
This unit should be properly grounded for your safety. Do not under any circumstances cut or remove the
ground wire from the power cord supplied.
Use of extension cords is not recommended.
This unit requires a standard 220V-50HZ electrical outlet.
The cord should be secured behind the wine refrigerator and not let exposed or dangling to prevent
accidental injury.
This machine is designed to be only used in "N" and "SN" climate.
OPERATING YOUR WINE REFRIGERATOR
It is recommended that you installed the wine refrigerator in a place where the ambient temperature is
between 10-26℃(50- 80°F) .If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected. For example, placing in extreme cold or hot conditions may cause
interior temperature to fluctuate. The range of 8-18℃(45-64°F )may not be reached.
The temperature may fluctuate depending on whether or not the interior light is on or off or whether the
bottles are located on the upper, middle or lower section.
Model No.
Volume
Rated Power
Rated Frequency
Input Power
Power Consumption kW·h/24h
Temperature Control Range
Net Weight
Gross Weight
Shape Size(WXHXD)mm
Warning
VT 2410
68L
220-240V
50Hz
130W
0.75 (15°C)
8-18°C/11-18ºC
20Kg
23Kg
450*725*525
11