Makita UB0800 Manual De Instrucciones Original página 9

IMPORTANT:
• While in mulching mode (optional accessory) the blower
MUST be in high speed position.
HOLDING THE TOOL
Before operating the unit, stand in the operating position.
Check for the following:
• Wear proper clothing, such as boots, safety glasses or
goggles, ear/hearing protection, gloves, long pants and
a long sleeve shirt.
WARNING:
To avoid serious personal injury, wear goggles or safety
•
glasses that comply with EN 166 or ANSI Z87.1 at all
times when operating this unit. Wear a face mask or
dust mask in dusty locations.
WARNING:
To prevent serious personal injury or damage to the
•
unit, make sure the blower tube or the mulcher tubes
and the bag are in place before operating the unit.
OPERATING TIPS (Fig. 7)
• Assure the unit is not directed at anybody or any loose
debris before starting the unit.
• Verify that the unit is in good working condition. Make
sure the tubes and guards are in place and secure.
• Always hold the unit with both hands when operating.
Keep a irm grip on both the front and rear handle or
•
grips.
• To reduce the risk of hearing loss associated with sound
level(s), hearing protection is required.
• Use the shoulder strap when using unit as a mulcher.
• Be sure the bag is installed properly and zipped closed
(when used as a mulcher).
• Operate power equipment only at reasonable hours
- not early in the morning or late at night when people
might be disturbed. Comply with times listed in local
ordinances. Usual recommendations are 9:00 am to
5:00 pm, Monday through Saturday.
• To reduce noise levels, limit the number of pieces of
equipment used at any one time.
• To reduce noise levels, operate the tool at low speed
if possible.
• Use rakes and brooms to loosen debris before
blowing.
• In dusty conditions, slightly dampen surfaces.
• Conserve water by using power blowers instead of
hoses for many lawn and garden applications, including
areas such as gutters, screens, patios, grills, porches,
and gardens.
• Watch out for children, pets, open windows or freshly
washed cars, and blow debris safely away.
• Clean up after using blowers and other equipment.
Dispose of debris appropriately.
NOTE:
• Please ensure that the Mulching Gate is completely
closed and locked.
AIR VENTS
• Never cover air vents. Keep them free from obstructions
and debris. They must always remain clear for proper
motor cooling.
WARNING:
To avoid serious personal injury, do not wear loose
•
itting clothing or articles such as scarves, strings,
chains, ties, etc., that could get drawn into the air vents.
To make sure long hair does not get drawn into the air
vents, tie back long hair.
OPERATING AS A BLOWER
Hold the blower irmly. Sweep from side to side with the
nozzle several inches above the ground or loor. Slowly
advance the unit, keeping the accumulated pile of debris
in front of you. Most dry blowing operations are better
suited to low speeds, rather than high. High speed blow-
ing is a better way to move heavier items like large debris
or gravel.
OPERATING AS A MULCHER (optional
accessory)
Hold the tool irmly, tilting the mulcher tubes (5–10 cm),
and use a sweeping action to collect light debris. The
debris will low into the bag. Items such as small leaves
and twigs will be mulched as they pass through the fan
housing. For longer bag life and increased performance,
empty the bag often.
CLEARING A BLOCKED TUBE / IMPELLER
WARNING:
To avoid serious personal injury, be sure the unit is OFF
•
and unplugged before clearing the impeller.
WARNING:
To avoid serious personal injury, always wear gloves to
•
protect yourself from the impeller blades or other sharp
objects.
• Slide the Power/Speed slide switch to the OFF position,
and wait until the unit comes to a complete stop.
• Unplug the unit.
• Remove the blower tube or mulcher tubes and the
bag.
• Carefully remove material blocking the tube or impeller.
Inspect the blades to ensure no damage has occurred.
Rotate the impeller blades by hand to ensure the block-
age is completely cleared.
• Reinstall the blower tube or mulcher tubes and the
bag.
• Plug the unit back into the power supply.
MAINTENANCE
WARNING:
• Never use water for cleaning your product, use only a
dry cloth. Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks may
result.
• Switch off and disconnect from the mains power supply
before cleaning or checking your product.
• Always empty the collection bag.
• Always store the product in a dry place ensuring the
cable is not likely to be damaged.
9