Snapper 020231 Manual Del Propietário página 4

SNAPPER T°
WARNING
, DO NOT touch hot surfaces.
, Allow equipment to cool before touching.
, The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
. Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
. In the State of California a spark attester is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands. If you equip the muffler with a spark attester, it must be
maintained in effective working order.
WARNING
. DO NOT wear loose clothing, jewelry or anything that may
be caught in the starter or other rotating parts.
. Tie up long hair and remove jewelry.
WARNING
I
. Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
WARNING
WHEN
ADJUSTING OR NAKING REPAIRSTOYOUR
PRESSURE WASHER
" Disconnect spark plug wire from spark plug and place wire
where it cannot contact spark plug.
CAUTION
DO NOT tamper with governed speed.
DO NOT operate pressure washer above rated pressure.
CAUTION
DO NOT secure spray gun in open position.
DO NOT leave spray gun unattended while machine is
running.
NEVER use a spray gun which does not have a trigger lock or
trigger guard in place and in working order.
Always be certain spray gun, nozzles and accessories are
correctly attached.
CAUTION
DO NOT point spray gun at glass when in jet spray mode.
NEVER aim spray gun at plants.
CAUTION
If you have questions about intended use, ask dealer or
contact Brigs & Stratton Power Products.
NEVER operate units with broken or missing parts, or
without protective housing or covers.
DO NOT by-pass any safety device on this machine.
Before starting pressure washer in cold weather, check all
parts of the equipment to be sure ice has not formed there.
NEVER move machine by pulling on high pressure hose. Use
handle provided on unit.
Check fuel system for leaks or signs of deterioration, such as
chafed or spongy hose, loose or missing clamps, or damaged
tank or cap. Correct all defects before operating pressure
washer.
This equipment is designed to be used with Brigs & Stratton
Power Products authorized parts ONLY. If equipment is used
with parts that DO NOT comply with minimum specifications,
user assumes all risks and liabilities.