How To Use Spraytips; Low Pressure - Snapper 020231 Manual Del Propietário

3000 psi
Ocultar thumbs Ver también para 020231:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
Place spray gun on hook attached to accessory tray on
right side of unit (Figure 15).
4.
Hang high pressure hose on hook attached to
accessory tray on [eft side of unit as shown on page 5.
How
to Use SprayTips
The quick-connect
on the nozzle extension
allows you to
switch between four different spray tips.The
spray tips vary
the spray pattern as shown (Figure 16).
CAUTION
* NEVER exchange spray tips without locking the safety latch
on the trigger.
Follow these
instructions
to change spray tips:
I.
Engage trigger lock on spray gun.
2.
Pull back collar on quick-connect
and pull current
spray tip off. Store spray tips in honer
provided on the
nozzle extension.
3.
Select desired
spray tip:
.
For gentle
rinse, select white 40 ° spray tip.
.
To scour
surface, select yellow
15 ° or red 0 ° spray
tip.
.
To apply chemical, select black spray tip.
Low
Pressure
Black
Use to apply
chemical
High
Pressure
40 ° White
15 ° Yellow
0 ° Red
4.
Pull back on collar, insert new spray tip and release co[hr.
Tug on spray tip to maize sure it is securely in place.
5.
For most effective cleaning, keep spray tip from 8 to
24 inches away from denning surface. If you get spray
tip too close, you may damage cleaning surface.
6.
DO NOT get closer than 6 inches when cleaning tires.
Cleaning
and Applying
Chemical
IMPORTANT:
Use soaps designed
specifically
for
pressure
washers.
Household
detergents could damage
the pump.
CAUTION
* Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
* Damage to equipment resulting from failure to follow this
instructionwill void warranty.
To apply
detergent
follow
these
steps:
I.
Review spray tip use.
2.
Prepare detergent solution as required by manufacturer.
3.
Hang detergent
solution on "J" hook attached to
accessory tray, as shown in Figure 17.
3.
Place
small
filter
end of detergent
siphoning
tube
into
detergent
container.
CAUTION
When inserting filter into a detergent solution bottle, route
tube to keep it from inadvertently contacting hot muffler.
4.
Maize sure black spray tip is installed.
NOTE:
Detergent
cannot
be applied with the high
pressure
spray tips (White,Yellow,
or Red).
5.
Make sure garden
hose is connected
to water
inlet.
Check that high pressure
hose is connected
to spray
gun and pump and start
engine.

Publicidad

Tabla de contenido
loading

Tabla de contenido