Snapper 020231 Manual Del Propietário página 8

Connect I-lose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1. Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 7).Tighten by hand.
.
Attach other end of high pressure hose to high
pressure outlet on pump (Figure 8).Tighten by hand.
.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 9). Clean screen if it contains
debris or replace if damaged. Refer to "O-Ring
Maintenance" section on page 13 if inlet screen is
damaged. DO NOT run pressure washer if inlet screen
is damaged.
4. Run water through your garden hose for 30 seconds
to clean out any debris.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than I00°F).
5. Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 9).
CAUTION
. Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Turn ON water and squeeze trigger on gun to purge
pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection.
Checklist Before Starting Engine
Review the unit's assemblyto ensure you haveperformed
all of the following.
I. Make sure handle is in place and secure.
2. Check that oil has been added to proper level in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for properly tightened hose connections.
5. Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
6. Provide a proper water supply at an adequate flow.
7. Be sure to read "Safety Rules" and "HowTo UseYour
Pressure Washer" before using the pressure washer.