Replacing The Return Spring - Makita DPC 6400 Manual De Instrucciones

Guide the cable into the recess (22) on the cable drum and use
the cable to turn the drum two turns in the direction shown by
the arrow.
Holding the cable drum in your left hand, straighten out the twist
in the cable with your right hand, pull the cable tight, and hold.
Release the cable drum. The drum´s spring force will now wind
the cable around the drum.
Repeat this procedure twice. The starter handle must stand out
from the fan housing.
NOTE: With the cable pulled all the way out, it must still be
possible to turn the pulley another 1/4 turn against the return
spring.
CAUTION! Injury hazard! When you pull out the starter
22
cable hold the starter handle firmly. It will whip back if the
cable pulley is released by accident.
When replaceing fan housing, it may be necessary to pull the
starter cable lightly so that the cable pulley catches.
A
Replacing
the return spring
Remove the fan housing (see above under "Replacing the
starter cable").
Take off circlip (1) (circlip pliers, see "Accessories").
2
Remove the cable pulley (2).
Unscrew screw (3) and carefully remove spring housing (4).
Remove screws (3) and carefully remove the return spring with
housing (4).
CAUTION: Danger of injury! If the spring is broken it may
pop out!
NOTE: The old spring should be recycled.
RE Y
Replacement return springs are delivered already tensioned
in the housing. Before installing, lightly grease the new spring
with multi-purpose grease, order No. 944 360 000.
Turn the cable pulley slightly when putting it back on, until you
hear it catch. Put the circlip back on.
Wind on the starter cable as described above under "Replacing
the starter cable".
4 3 1
When replaceing fan housing, it may be necessary to pull the
starter cable lightly so that the cable pulley catches.
B
22