Optional Accessories; Replacing Carbon Brushes - Makita 4101RH Manual De Instrucciones

When changing the wheel, clean the cover (B) at the
same time. Loosen the screw securing the cover (B) and
remove the cover (B). Wash off accumulation of dust
inside the cover (B) and wipe it. Then attach the cover
(B) to the tool by tightening the screw. Accumulation of
dust inside the covers may cause a malfunction of the
tool.
1
003549
CAUTION:
When using the tool, be sure to attach the covers
•
(A) and (B).

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
First, remove the cover (A).
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1 2 2
003550
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
1. Cover (B)
2. Screw
2
1. Limit mark
1
1. Brush holder cap
2. Screwdriver

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Diamond wheels
•
Rip fence (Guide rule)
•
Hex wrench 5
•
Wrench 22
•
Pressure regulator assembly
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
9
or attachments
Only use accessory or
are