Starting the engine
When starting the engine, observe the precautions described from Page 4 in the section "For safe use of your prod-
uct" to ensure that you operate the product correctly.
If the cutting attachment rotates even though the throttle trigger is in the idle speed position when the engine is start-
ed, adjust the carburettor before using the product.
Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
When starting engine using throttle latch, cutting attachment rotates. After engine starts, pull throttle trigger slightly
to release throttle latch immediately. Never use throttle latch for operation.
The rotating blade can cause injury.
NOTE
Pull out the starter grip gently at first, and then more rapidly. Do not pull the starter rope out to more than 2/3 of its length.
Do not let go of the starter grip as it returns.
Starting a cold engine
1. Ignition switch
2. Throttle trigger
1. Purge bulb
2. Choke lever
3. Cold Start (CLOSE)
WARNING
3. Throttle trigger lockout
4. Thorttle latch
4. Run (OPEN)
5. Starter handle
Engine operation
Engine operation
(Connect the spark plug cap if the product has been in storage for
a long period of time)
The starting procedure depends on whether the engine is cold or
warm. A cold engine is started as follows.
1.
Remove the trimmer blade cover and check the trimmer
blade. If anything is wrong, replace it with a new one.
2.
Placing the product on level ground, check to ensure that the
blade does not come into contact with the surface of the
ground or any other impediment using a beam or other such
implement.
3.
Check that there are no fuel leaks.
4.
Move the ignition switch to the Start position.
5.
Make sure that the throttle trigger is at the idle speed posi-
tion.
6.
Move the choke lever to the Closed position.
7.
Alternately press and release the purge bulb until the fuel is
sucked up into it.
27