Speed Selection; Magnet Detection; Extension Cable Selection - Walter ICECUT Mini Manual De Instrucciones

ICECUT MINI Low-Profile Original Instructions 03-2019

8) SPEED SELECTION

The ICECUT MINI is fitted with a 1-speed gearbox with a variable speed selector.
The speed selection dial is used to reduce the output speed when using larger cutters.
Speed Controller Setting
Speed Selector
Position Position 1 Position 2 Position 3 Position 4 Position 5 Position 6
RPM 250/min 300/min 350/min 400/min 450/min 500/min

9) MAGNET DETECTION

It is advised that when working on thin material a packing piece should be used to increase the
material thickness under the magnet. Working on thin material without a packing piece will reduce
the magnet holding force.
It is advised that the drill is to be operated on ferrous material 12mm thick and above. Damage to
the magnet base, such as pitting, will affect the strength of the magnet holding force.

10) EXTENSION CABLE SELECTION

The machines are factory fitted with a 3 metre length of cable having three conductors 1.5mm²
LIVE, NEUTRAL and EARTH. If it becomes necessary to fit an extension cable from the power
source, care must be taken in using a cable of adequate capacity. Failure to do so will result in a
loss of traction by the magnet and a reduction of power from the motor.
Assuming a normal AC supply of the correct voltage, it is recommended that the following
extension lengths shall not be exceeded:
For 120V supply: 3 metres (11.5 feet) of 3 core x 14AWG
ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE CHANGING CUTTERS.
10