Dolmar TM-98.14 H2D Manual De Instrucciones página 98

12
EN
3.6 FITTING THE STONE-GUARD
Inside the stone-guard (1), fit the spring (2)
by inserting the terminal (2a) into the hole
and turning it so that both the spring (2) and
the terminal (2a) are securely positoned in
their seatings.
Position the stone-guard (1) in line with the
cutting deck brackets (3). Using a screwdriv-
er, turn the second terminal (2b) of the
spring (2) to bring it outside the stone-guard.
Fit the pin (4) in the holes on the brackets (3)
and on the stone-guard, so that it passes
thrugh the coils of the spring (2) and the
drilled end comes out of the inner most
bracket.
Fit the cotter pin (5) in the hole (4a) of the pin
(4) and turn the pin until the two ends (5a) of
the split pin can be bend (using pliers), so
that it cannot slip out and let the pin fall out
(4).
WARNING!
!
works correctly and keep the stone-
guard securely lowered. Make sure that
the pin is fitted properly to prevent it
from falling out accidently.
Check that the spring
UNPACKING AND ASSEMBLY
1 2a
2
1
3
4
4
4a 5
2
2b
2
2b
3
1
2
3
5a