Remote Control Unit - Technibel MRAF98C5T Instrucciones De Uso

REMOTE CONTROL UNIT

DISPLAY
Information is displayed when the remote controller is switched on. If switched off, only the operating mode, the room
temperature and the clock are shown
Operation mode
*
Automatic
Cooling
*
Heating
Dehumidification
Fan
Night Oscillation
mode Flap
SENSOR
A temperature sensor inside the remote
control unit detects the room temperature.
TEMPERATURE SENSOR SELECTOR
Press the I FEEL button to modify the
active setting for room temperature
detection (from remote controller to air
conditioner and viceversa)
TEMPERATURE SETTING BUTTONS
TEMP - (cooler)
Press this button to decrease the set
temperature.
TEMP + (warmer)
Press this button to increase the set
temperature.
PUSH-BUTTON FLAP
To press this push-button in order to
select the wished function.
Fixed: six position
Continous oscillations
Automatically oscillations
ON/OFF BUTTON
This button turns the air conditioner ON
and OFF.
"SEL TYPE" BUTTON
Press this button in order to:
• set the clock
• set the ON/OFF timer
For details refer to paragraphs "SETTING
THE HOUR" and "SETTING THE TIMER".
"FAN " BUTTON
Fan speed is automatically
selected by the microcomputer.
High speed.
Medium speed.
Low speed.
Fan speed
Automatic
Medium speed
High speed
Low speed
TIMER AND PRESENT TIME SETTING
BUTTONS
With these buttons is possible to set the
clock and the timer. For details refer to
paragraphs " SETTING THE HOUR" and
"SETTING THE TIMER2.
I FEEL mode is active
(remote controller
sensor active)
Displayed when
transmitting data
Timer modes
Clock
5
Room
temperature
Set point
temperature
TRANSMITTER
When you press the buttons of the remote
control unit, the mark
appears on the display to transmit the
setting changes to the receiver in the air
conditioner.
"NIGHT" BUTTON
For details, see "NIGHT MODE".
When you press this button in the COOL,
HEAT or DRY mode,
appears on the display and the
microcomputer in the remote control unit
will adjust the set temperature to save
energy.
INACTIVE BUTTONS
"TIMER SEL" BUTTON
Press this button to select the type of
timer to activate. For details refer to
paragraph "SETTING THE TIMER".
MODE SELECTOR BUTTON
Press this button to modify the air conditioner mode.
*
(automatic)
When this setting is selected, the air conditioner
calculates the difference between the thermostat setting
and the room temperature and automatically switches to
the "cool" or "heat" mode.
*
(heating)
The air conditioner makes the room warmer.
(dry)
The air conditioner reduces the humidity in the room.
(cooling)
The air conditioner makes the room cooler.
(fan)
The air conditioner works only as a circulation fan.
*
HEAT PUMP Models
GB
the mark
only