Canopy Assembly; Blade Assembly - Craftmade ASH60TBWB5 Guia De Instalacion

9. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the
open end of the hanging bracket. Partially
loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of
slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was
removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy
cover with screwheads in bottom of canopy.
Turn canopy cover to the right (clockwise)
until it stops.

10. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor housing, aligning holes in
blade with holes in blade arm (located on the
INSIDE of the motor housing and can be seen
from the UNDERSIDE of the motor
housing)--REFER TO DRAWING AT RIGHT. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining blade.
Note: Tighten blade screws twice a year.
screw
canopy
canopy cover
blade attachment
screws and washers
page 7
hanging bracket
screw
motor housing
blade
blade arm
(inside motor
housing)