Operating Instructions
Operating Instructions
Remote control
The remote control and control panel will look like one of the following pictures.
2
7
4
1. POWER BUTTON
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
2. OPERATION MODE SELECTION BUTTON
Everytime you push this button, it will toggle COOL, FAN and HEAT.
C o o l :
Compressor runs and cools the room.
and FAN buttons to set the desied temperature
Use the
and circulation fan speed.
Fan :
Fan circulate air but compressor does not run.
Use the FAN button to set the desired fan speed.
Heat:
Heater runs and heats the room.
and FAN buttons to set the desied temperature
Use the
and circulation fan speed.
3. ON/OFF TIMER BUTTON
Everytime you push this button, timer is set as follows.(1Hour
6Hours
7Hours
You will usually use shut-off time while you sleep.
For your sleeping comfort,once timer is set,the temperature setting will raise 2 F after
30min and once again after another 30min.
4. FAN SPEED SELECTOR
Everytime you push this button, it is set as follows. (Hi[
5. ROOM TEMPERATURE SETTING BUTTON
This button can automatically control the temperature of the room. The temperature can be set within a
range of 60° F to 86° F by 1° F.
16 Room Air Conditioner
3
5
6
8Hours
9Hours
8
5
1
3
7
2Hours
10Hours
11Hours
]
Low[
REMOTE CONTROLLER
Power
Temp
Fan Speed
Timer
Mode
Energy
Auto
Saver
Swing
3Hours
4Hours
12Hours
Cancel)
。
]
Hi[
]....)
1
4
2
6
5Hours