Urmet 1083/9 Manual Del Usario página 15

association must be created between the buttons and the users of the different column proceed as
follows:
• Access advanced configuration by turning the two rotary switches to position 99 (the yellow LED will
light up).
• Set the ID dip-switch to the code of the first column in the system (column 0 typically).
• Press the button corresponding to user 0 of the selected column. All the subsequent buttons will be
automatically associated to the users of the column itself in sequence.
• Repeat the operation on all the columns.
• Reset the ID dip-switch in start position.
• To quit advanced configuration, turn the two rotary switches to the door opening line and the guaranteed
conversation time setting positions. The yellow LED will go out.
Example:
• System with 3 columns, the first with 4 users, the second with 6 users and the third with 8 users.
• Access advanced configuration.
• Set the ID dip-switch to 0.
• Press the upper button of the door unit (first button).
• Set the ID dip-switch to 1.
• Press third button of the first button module (fifth button) to associate user 0 of column 1 in this manner.
• Set the ID dip-switch to .
• Press first button of the third button module (eleventh button) to associate user 0 of column 2 in this
manner.
• Reset the ID dip-switch in start position.
• Quit advanced configuration mode.
The final configuration will be:
§
The configuration of column 0 is not required if the default settings of the door unit are maintained
because all buttons are assigned to this column.
Repeat the operation on all the main door units.
If the door units are configured as secondary, but each one must call a different group of users, the following
steps can be performed:
• Access to advanced configuration by setting both the two rotary dip-switches to position '9' (the yellow
led turns on);
• Set the ID dip-switch of the call module with the apartment station code that will be associated to the
first button (offset);
§
The offset code can only be included between 0 and 31
• Change the position of AUX dip-switch no. 5 (the call module emits a confirmation tone);
DS1083-034A
Column 0 start
4 USERS
Column 1 start Column 2 start
6 USERS
P5÷P8
P9÷P12
1083/17 (1)
P1÷P4
OUTPUT
8 USERS
P13÷P16
15