Publicidad
Idiomas disponibles
Idiomas disponibles
Playing a Record
- Place the record of your choice on the turntable. If required, do
not forget to place the adaptor on the record spindle.
- Choose the desired playing speed using the speed selection
switch between 33.3, 45 and 78rpm.
- Turn on the Rotary Power Switch, note that this also controls volume.
- Release the tone arm lock.
- Raise the arm with your hand lightly.
- Place the stylus vertically over the first track of the record and the
turntable will start turning automatically.
- Put down the stylus slowly on to the record to play.
- When a record comes to an end, the turntable will stop
automatically if the auto-stop switch is on the ON position. If the
switch is on the off position then it will keep revolving until the tone
arm is returned to the tone arm rest.
- Lift up the tone arm and put it on the rest position when finished.
- Replace the protective cap on the stylus and close the tone arm lock.
- Turn off power at mains.
Listen to USB SD tracks
- Turn the volume knob in a clockwise direction to turn the
equipment on.
- Use the function selector to select USB mode.
Pg. 5
Publicidad
