Safety Rules; General Safety Rules - Promax MO-160 Manual Del Usuario

USER'S MANUAL. MO-160

2 SAFETY RULES

2.1 General safety rules

*
The safety could not be assured if the instructions for use are not closely
followed.
*
Use this equipment connected only to systems with their negative of
measurement connected to ground potential.
*
This is a class I equipment, for safety reasons plug it to a supply line with the
corresponding ground terminal
*
This equipment can be used in Overvoltage Category II installations and
Pollution Degree 1 environments.
*
When using some of the following accessories use only the specified ones to
ensure safety.
Power cord
*
Observe all specified ratings both of supply and measurement.
*
Remember that voltages higher than 70 V DC or 33 V AC rms are dangerous.
*
Use this instrument under the specified environmental conditions.
*
The user is only authorized to carry out the following maintenance operations:
Replace the fuses of the specified type and value.
On the Maintenance paragraph the proper instructions are given.
Any other change on the equipment should be carried out by qualified personnel.
*
The negative of measurement is at ground potential.
*
Do not obstruct the ventilation system of the instrument.
*
Use for the signal inputs/outputs, specially when working with high levels,
appropriate low radiation cables.
*
Follow the cleaning instructions described in the Maintenance paragraph.
02/2008
CA005
Page 7