Handle Assembly - GRE VCB10P Manual De Instrucciones

2. Installation
2.1 Filter element assembly and body parts assembly
Assemble the body parts in the direction of the arrow.
1. 1.
2.2 Assembly of suction head
Insert the entire suction head directly
into the Cover the garbage.
3. Power on and Turbo speed mode
3.1 Press and hold the power switch button of the cleaner for 2-3 seconds.
If the «green» indicator light is always on, it means the machine is
started. Please put the product into the water for operation, so as to
prevent the seal failure of the oil seal when the product is idling. At
this time, the cleaner is in low speed mode.
3.2 Press the switch button again, you will find that a "blue" indicator
light is on, and the cleaner enters the «high speed mode». At this
time, the cleaner can clean up a large number of large particles of
sediment at the bottom of the pool.
3.3 When you press the switch button for the third time, all the
indicator lights are off and the cleaner is turned off.
Notes: The high and low speed mode of the cleaner
is switched from «low speed mode» to «high
speed mode», If you want to switch from "high
speed mode" to «low speed mode», you need to
shut down and operate 3.1 again.
2. 2.

2.3 Handle assembly

(1) Handle assembly.
This handle is used to clean
walls, steps, seats and corners,
as shown in figure "A»
Note: the product can be connected with handle A or standard
telescopic rod B.
3. 3.
(2) Assembly of telescopic rod
(included)
Cleaner can be connected to
a standard telescopic rod, as
shown in figure "B».
A
Indicator light
High
NO/Low
speed speed
4. 4.
B
ON/OFF
OFF