Troubleshooting - GRE VCB10P Manual De Instrucciones

Troubleshooting

If you have problems with your cleaner, follow the troubleshooting steps below to restore performance.
Note: turn off the power before making any repairs.
Problem
Unable to clean garbage
Garbage flows out of the front
transparency
Rubbish is leaking out of the filter
bag
The handle / telescopic link cannot
be assembled correctly
The cleaner cannot be charged.
Possible causes
The battery is low
Impeller clogging
Impeller damage
The filter is full
There is too much garbage in the
filter element
Anti pour blade damage
The garbage is too full
The filter bag is damaged
V-clip damaged
Battery damage.
The charging cable is not fully
connected to the external adapter
and the robot.
The external adapter is broken.
Solution
Please recharge.
Turn off the cleaner and check the
impeller to remove the garbage. If
necessary, contact your dealer for
further instructions. Warning! Be-
fore servicing the equipment, make
sure that the cleaner is turned off.
Please contact your dealer for
replacement.
Clean up the garbage from the filter
screen.
Clean the garbage of filter element.
Replace the anti reverse flow pie-
ce. Please contact your dealer for
replacement parts.
Clean the waste of filter screen and
filter element.
Replace the filter bag. Please con-
tact your dealer for replacement
parts.
Replace the v-clip. Please contact
your dealer for replacement parts.
Please contact the dealer to re-
place the battery. Warning! Don't
turn on the cleaner and replace the
battery yourself. This can cause se-
rious or fatal injury, so the warranty
will not be valid.
Make sure the charger cable is
properly and completely connected
to the external adapter and cleaner.
Please refer to the user manual.
Contact the dealer for replacement.
Warning! Using the wrong external
adapter will result in damage to
the cleaner / battery and void the
warranty.