Assembly And Adjustment - Black and Decker LI3100 Manual De Instrucciones

90550370 LI3100.qxd
6. To maximize battery life:
a. Do not fully discharge batteries.
b. Fully recharge batteries after each use.
c. Store tool in a location where the surrounding air temperature is approximately
40°F - 75°F (4.5°C - 24°C).
d. Disconnect charger from tool after charge is complete.
When disconnecting the charger from the tool, be sure to unplug the charger from the
outlet first, then disconnect the charger cord from the tool.
Safety Warnings and Instructions: Drilling
WARNING: Tool may stall (if overloaded or improperly used) causing a twist. To
reduce the risk of injury always expect the stall. Grip the tool firmly to control the
twisting action and prevent loss of control which could cause personal injury. If a stall does
occur, release the trigger immediately and determine the reason for the stall before
re-starting.

ASSEMBLY AND ADJUSTMENT

INSERTING AND REMOVING BITS
(FIGURE C)
• To install a bit simply insert it into the cavity
in the hex spindle (4) as shown in figure C.
To remove the bit pull it straight out.
FORWARD / REVERSE / LOCK OFF
SLIDER (FIGURE D)
• To select forward or reverse rotation, use
the forward / reverse slider (2) (see arrows
on the slider).
NOTE: When the forward / reverse slider is
in the central position the tool is locked off to
prevent accidental actuation or battery
discharge.
OPERATING INSTRUCTIONS
SWITCHING ON AND OFF
• To run the tool, press the switch (1).
• To stop the tool, release the switch.
• To lock the tool in the off position, move the forward / reverse slider (2) to the central
position.
SCREW DRIVING
• Insert the appropriate screwdriver bit into the hex spindle.
• Select forward or reverse rotation.
SCREW DRIVING NOTES:
• Do not use double ended screwdriver bits.
5/4/09 8:00 AM Page 7
7
WARNING: Fire Hazard.
C
4
D