RedMax TR2300S Manual De Instrucciones página 14

Tabla de contenido

Publicidad

14
English
5. For safe operation
1. Grip the handles firmly with both hands using your
whole hand. Place your feet slightly apart (slightly
further apart than the width of your shoulders) so
that your weight is distributed evenly across both
legs, and always be sure to maintain a steady, even
posture while working.
2. Keep cutting attachment below waist level.
3. Maintain the speed of the engine at the level
required to perform cutting work, and never raise the
speed of the engine above the level necessary.
4. If the unit start to shake or vibrate, turn off the
engine and check the whole unit. Do not use it until
the trouble has been properly corrected.
5. Keep all parts of your body away from rotating
cutting attachment and hot surfaces.
6. Never touch the muffler, spark plug, or other metallic
parts of the engine while the engine is in operation
or immediately after shutting down the engine. Doing
so could result in serious burns or electrical shock.
• IF SOMEONE COMES
1. Guard against hazardous situations at all times.
Warn adults to keep pets and children away from the
area. Be careful if you are approached. Injury may
result from flying debris.
2. If someone calls out or otherwise interrupts you
while working, always be sure to turn off the engine
before turning around.
■ MAINTENANCE
1. In order to maintain your product in proper working
order, perform the maintenance and checking
operations described in the manual at regular
intervals.
2. Always be sure to turn off the engine before
performing any maintenance or checking
procedures.
(1) Chheck ok !
WARNING
The metallic parts reach high temperatures
immediately after stopping the engine.
3. When replacing the cutting attachment or any other
part, or when replacing the oil or any lubricant,
always be sure to use only RedMax products or
products which have been certified by RedMax
for use with the RedMax product.
4. In the event that any part must be replaced or any
maintenance or repair work not described in this

Publicidad

Tabla de contenido
loading

Tabla de contenido