Tripp-Lite PDU15NETLX El Manual Del Propietario página 5

Features
Network Interface
A
Ethernet Port: RJ45 jack connects the PDU's Network Interface to the network
using a standard Ethernet patch cable. LEDs
conditions (shown in the table below).
B
RJ45 Configuration Port: Use this port to provide a direct terminal connection
to a computer with a terminal emulation program. An RJ45 to DB9 cable (part
number 73-1243) is included with the PDU. To request a replacement cable,
visit www.tripplite.com for ordering information.
C
USB Type-A Port: Use this port to connect up to three linked Tripp Lite
EnviroSense2 modules (E2MT, E2MTDO, E2MTDI, E2MTHDI) for a variety of
environmental monitoring and control options. See www.tripplite.com for more
information about these modules.
Note: Do not connect a keyboard or mouse to this port.
D
Reset Button: Accessible through a small hole on the faceplate above the RJ45
Configuration Port. Press once to reset the Network Interface. Press and hold for
15 seconds to reset the Network Interface to factory default settings.
Note: PDU loads will not be affected.
E
Status LED: Shows the Network Interface status (shown in the table below).
Identifier LED Function LED Color
A1
A2
E
17-02-373-9336CA.indb 5
E
D B
Ethernet Green
Link/Activity
Indicator
Ethernet Yellow
Network
Speed
Indicator
Network Green
Interface
Status
Green/
Orange
A2 A1
C A
and indicate the operating
A1 A2
Status Description
Flashing There is network activity on the port
Off There is no network activity on the
port
On steady 100 Mbps network speed
Off
10 Mbps speed if
Off
No network activity if
On steady Normal operation
Single flash Power up indicator
Off No power or card is initializing
Alternating Software update in progress
(~1/sec.)
Alternating Restoring factory default
(~2/sec.) configuration
5
is flashing
A1
is also off
A1
6/2/2017 2:08:41 PM