Storage And Disposal - brennenstuhl WV 4/16A IP44 Manual De Instrucciones

089417 BA_Wandverteiler WV 4_16 4_32.qxp 07.02.18 15:31 Seite 17
WV 4/16A IP44 · WV 4/32A IP44
Dry cleaning
For dry cleaning, you can use a hand brush and a clean cloth.
– Remove dust and dirt using a hand brush first.
– Then wipe the device using a clean dry cloth.
Wet cleaning
Only use clean water for wet cleaning.
– Remove dust and dirt using a hand brush first.
– Then wipe the device using a clean damp cloth.
Decommissioning and disassembly
DANGER
Working at live parts may cause severe or fatal injuries.
– De-energize the supply cable of the device for disassembly.
– Secure the system against unintended re-activation of the supply voltage by other persons.
– Ensure that the supply cable is de-energized before starting disassembly.
Decommissioning and dismounting the device
– Open the device (see "Mounting and commissioning" section).
– The bottom part of the housing is attached to the wall with screws at different positions of the
housing. Loosen the screws at the housing bottom and take the device off the wall.

Storage and disposal

Storing the device
For proper storage and to ensure the failure-free operation of the device later, observe the following
instructions.
– Clean the device prior to storage. (see "Cleaning and care" section).
– Store the device in its original packaging or in a suitable cardboard box.
– Store the device in a dry and temperature-controlled room at a storage temperature between
0° C and +40° C.
Disposing of the device
Recycle the old distribution box or dispose of it properly. Always observe local regulations.
The distribution box must not be disposed of with the household waste.
Proper disposal prevents damage to the environment and hazards to personal health.
17