ZUCCHETTI KOS Quadrat Relax Manual De Instalación, Uso Y Mantenimiento página 38

The remote control is ready to use since connected to the Quadrat Relax in the factory.
In the event of need (i.e. remote control replacement with a new one), the remote control can be re-connected following the procedure
indicated in chapter "Quadrat Relax connection". The reset procedure is not necessary for re-connection but can be helpful in the event
of remote control problems; in this case, the remote control must be re-connected to the Quadrat Relax at the end of the procedure fol-
lowing the procedure indicated in chapter "Quadrat Relax connection".
The remote control turns off after a few minutes of disuse to turn back on as soon as it is moved.
Remote control keys are capacitive type. The command is at release and not pressure.
TEMPERATURE SETTINGS
1 Press the or key.
2 " SP" (SET POINT) appears on the screen.
3 Use the or keys to increase or decrease the temperature.
QUADRAT RELAX CONNECTION
1 Turn the pool off and back on using the main switch (position
"I - on"- position "O-off").
2 Position the remote control in the load area.
3 The 4 blue lines and then the
3 Press the key until the temperature appears on the remote
control display: now the latter is connected to the Quadrat Relax.
REMOTE CONTROL RESET
1 Position the remote control in the load area.
2 Press the key until "00" appears on the display and the
LEDs light up
3 Press the key until the key lights up
key turn on.
38
Quadrat Relax
1 2
1
OFF
ON
3
1
2
TEMPERATURE SETTINGS
3
CONNECTION
2
4
RESET
2
3