Publicidad
Idiomas disponibles
Idiomas disponibles
Publicidad
Tabla de contenido
Manuales relacionados para Onn ONA16TM010
Resumen de contenidos para Onn ONA16TM010
- Página 1 32-47” Tilting TV Wall Mount Model: ONA16TM010 PRODUCT GUIDE...
- Página 2 IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL PRIOR TO USE Before getting started, let’s make sure this mount is perfect for you! Para Español ver página 14 Does your TV No — Perfect! (including accessories) 80 lbs.
- Página 3 Dimensions TV INTERFACE 15.75 [mm] 2.95 2.95 16.93 15.75 OFFSET 16.79 426.5 WALL PLATE SIDE VIEW - TILT RANGE 4.75 120.7 10° 3.91 99.4 ESTIMATED 32" TV WALL PLATE OPENING SIDE VIEW - RETRACTED 15.45 392.5 6.00 152.4 2.93 74.4 5°...
- Página 4 Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
- Página 5 Parts and Hardware for STEP 2 Concrete Installation Kit (NOT INCLUDED) Contact Customer Service at 877-689-1665 to have these Wall Plate additional pieces shipped directly to you. Lag Bolts 5/16 x 2¾ in. C1 x4 Washers Lag Bolts .695 x .350 x .075 in. C2 x4 5/16 x 2¾...
- Página 6 STEP 1 Attach Brackets to TV Standard configurations are shown. For special applications, or if you 1.1 Select TV Screw Diameter 1.2 Select TV Screw Length are uncertain about your hardware selection, Hand thread screws into the threaded inserts If your TV has a flat back, AND you want your TV closer to contact Customer Service on the back of your TV to determine which the wall, use the shorter screws (a).
- Página 7 1.3 Attach TV Brackets Center the TV brackets over your TV hole pattern as shown - making sure the brackets are level. NOTE: The tilt tension knob TV brackets should be oriented to the outside edges. Install using the screw/washer/spacer combination (a) or (b) you selected for your TV. CAUTION: Avoid potential personal injuries and property damage! DO NOT use power tools for this step.
-
Página 8: Wood Stud Installation
Attach Wall Plate STEP 2A Wood Stud Installation CAUTION: Avoid potential personal injury or property damage! • Drywall covering the wall must not exceed 5/8 in. (16 mm) • Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 1½ x 3½ in. (38 x 89 mm) Locate your stud. - Página 9 Drill two pilot holes using a 7/32 in. (5.5 mm) diameter drill bit. IMPORTANT: Pilot holes must be drilled to a depth of 2 3/4 in. (69.8 mm). Be sure to drill into the center of the studs. Install wall plate using two lag bolts and two washers .
- Página 10 Attach Wall Plate Solid Concrete or Concrete Block Installation STEP 2B CAUTION: Avoid potential personal injury or property damage! Concrete Installation Kit is not included (see page 5) Contact Customer Service at • Mount the wall plate directly onto the concrete surface 877-689-1665 to have the additional hardware •...
- Página 11 Insert three anchors (Fischer UX 10 x 60R - included in the Concrete Installation Kit*). CAUTION: Be sure the anchors are seated flush with the concrete surface. Install wall plate using three lag bolts and three washers (use only the lag bolts and washers from the Concrete Installation Kit*). Tighten the lag bolts only until the washers are pulled firmly against the wall plate...
- Página 12 STEP 3 Attach TV to Wall Plate HEAVY! You may need assistance with this step. IMPORTANT: You will hear an audible click when the TV bracket is securely fastened to the wall plate...
- Página 13 Adjustments TILT LATERAL SHIFT REMOVING THE TV Loosen the knob on the TV bracket Pull down on the straps and lift the TV Slowly slide the TV along wall plate to adjust the tilt of your TV. Tighten up and out away from the wall plate. the knob when your TV is set to the desired tilt.
-
Página 14: Listo Para Comenzar
INSTRUCCIONES DE SEGURIDAD IMPORTANTES. ESPAÑOL CONSÉRVELAS. LEA TODO EL MANUAL ANTES DE UTILIZAR ESTE PRODUCTO. Antes de comenzar, verifiquemos que este soporte sea el ideal para sus necesidades. ¿Su televisor pesa más de 36,2 kg (80 36,2 kg No — ¡Perfecto! libras), incluidos (80 lbs.) Sí... - Página 15 Dimensiones ESPAÑOL Ver página 3 Piezas y elementos de sujeción suministrados Ver página 4 ADVERTENCIA: Este producto contiene piezas pequeñas que, si fuesen tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones. Si faltan piezas o alguna está dañada, no devuelva el artículo al distribuidor;...
-
Página 16: Paso 2A Fijar La Placa Mural
ESPAÑOL PASO 2A Fijar la placa mural Montantes de madera Ver página 8 PRECAUCIÓN: Evite lesiones y daños materiales. ● El yeso que recubre la pared no debe exceder los 16 mm (5/8 pulgada). ● Tamaño mínimo del montante de madera: común 51 mm x 102 mm (2 x 4 pulgadas) (nominal 38 mm x 89 mm [1½ x 3½ pulgadas]) Localice un montante. -
Página 17: Paso 3 Instalar El Televisor En La Pared
Coloque la placa mural en la pared a la altura que desee. ESPAÑOL Nivele la placa mural y marque la ubicación de los orificios. Realice los orificios guía con una mecha para mampostería de 10 mm (3/8’’) de diámetro. IMPORTANTE: Los orificios guía deben realizarse hasta una profundidad de 75 mm (3’’). Nunca perfore el cemento que une los bloques. Introduzca tres anclajes (Fischer UX 10 x 60R - incluidos en el Kit de instalación en hormigón *). - Página 20 For Customer Service, Please Call: 877-689-1665 ©2016 Wal-Mart Stores, Inc. Onn is a registered trademark of Wal-Mart Stores, Inc. All Rights Reserved. MADE IN CHINA Distributed by Wal-Mart Stores, Inc. Bentonville, AR 72716 6901-002571 00...