Sony SU-PF1L Manual Del Usuario página 5

When carrying the Floating Stand
Trying to move the Floating Stand alone, or without following the proper procedures, may cause injury. To avoid
this, be sure to follow the advice given below.
• Be sure that two or more persons carry the Floating Stand only after removing the Display Unit.
• Be careful not to allow your toes to be pinched under the bottom plate or the corner of the glass.
Do not subject the glass to excessive shock.
This stand is made of tempered glass, but care should be taken. If the glass breaks,
glass fragments could cause injury, so observe the precautions below.
• Do not hit the glass or drop sharp-pointed objects on the glass. Avoid excessive
shock.
• Do not scratch or poke the glass with sharp-edged objects.
• Do not let hard objects such as a vacuum cleaner hit the edges of the glass.
Note on installation
Install the stand on a solid and flat floor. Do not allow the stand to be installed at an angle or incline. To avoid this,
observe the following precautions.
– If you install the stand on a soft surface such as a mat or a carpet, lay a board over the designated location
beforehand.
– Do not install the stand in a place subject to direct sunlight or near a heater.
– Do not install the stand in a hot or humid place, or outdoors.
Note on use
To keep the stand clean, occasionally wipe the stand with a dry soft cloth. Stubborn stains may be removed with a
cloth slightly dampened with diluted detergent. Then wipe the area with a dry soft cloth. Do not use any type of
chemicals, such as thinner or benzine, as they may damage the finish of the stand.
5
(US)