Craftsman 580.752820 Instrucciones De Uso página 19

Ocultar thumbs Ver también para 580.752820:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Service
Air Cleaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements
are available at your local
Sears service center.
To service the air cleaner, follow these steps:
1.
Loosen two screws and lift off cover.
,
3.
Two Scows
L,
"_-----_
Cover
Cartridge
Base
....
Carefully remove air cleaner from base.
Install clean (or new) air cleaner in base. Air
cleaner must fit securely in base.
4.
Place cover over air cleaner and tighten screws.
NOTE: You can purchase new air filter elements by
calling 1-800-4-MY-HOME (469-4663).
Service
Spark
Plug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
1.
Clean area around spark plug.
2.
Remove and inspect spark plug.
3.
Replace spark plug if electrodes are worn, or if
insulator is cracked or chipped.
4.
For replacement use either the standard resistor
spark plug, Champion RC12YC or the long life
platinum spark plug, Champion RC12PYP.
5.
Check electrode gap with wire feeler gauge and
set gap at 0.020 inches (0.50mm), if necessary.
_-_
f_
...........
Spark Arrester
Service
Your engine is not factory-equipped with a spark arrester.
In some areas, it is illegal to operate an engine without a
spark arrester. Check local laws and regulations. A spark
arrester is available from your nearest Sears service
dealer. If you need to order a spark arrester, please call
1-800-4-MY-HOME (469-4663).
The spark arrester must be serviced every 50 hours to
keep it functioning as designed.
If the engine has been running, the muffler will be very
hot. Allow the muffler to cool before servicing the
spark arrester.
WARNING
DO NOT touch hot surfaces
and avoid hot exhaust
gases.
Allow
equipment
to cool before
touching.
Keep at least 5 ft. (152 cm) clearance
on all sides
of
pressure
washer
including
overhead.
Code of Federal
Regulation
(CFR)
Title 36 Parks,
Forests,
and Public
Property
require
equipment
powered
by an internal
combustion
engine
to have a spark
arrester,
maintained
in effective
working
order,
complying
to USDA
Forest
service
standard
5100-1C
or later
revision.
In the State of California
a spark
arrester
is
required
under section
4442
of the California
Public
resources
code.
Other
states
may have similar
laws.
Remove spark arrester screen for cleaning and
inspection.
Replace if screen is damaged.
Air Cooling
System
Over time debris may accumulate in cylinder cooling
fins and cannot be observed without partial engine
disassembly.
For this reason, we recommend you
have an authorized Sears service dealer clean the
cooling system per recommended intervals (see
"Maintenance Schedule" on page 15). Equally
important is to keep top of engine free from debris.
See "Clean Debris".
6.
Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-4-MY-HOME (469-4663).
19

Publicidad

Tabla de contenido
loading

Tabla de contenido