Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Attach Hose Reel
Attach hose reel to handle as shown on page 6
according to instruction sheet included with hose reel.
NOTE: There may be small tube adapters included
with the hose reel kit that is not used on this model.
IMPORTANT:
You must take the hose off the reel
when operating your pressure washer. The reel is for
hose storage purposes only.
Add Engine
Oil
CAUTION!
Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
1.
Place pressure washer on a level surface.
2.
Clean area around oil fill and remove oil dipstick.
3.
Using oil funnel (optional), slowly pour entire
contents of provided oil bottle (18 oz.)into oil fill
opening.
4.
Replace oil dipstick and fully tighten.
NOTE: See the section "Oil" on page 18 to review oil
recommendations.
Add Fuel
NOTE: This gasoline engine is certified to operate on
gasoline. Exhaust Emission Control System: EM
(Engine Modifications).
WARNING
WHEN ADDING FUEL
Turn pressure washer OFF and let it cool at least 2
minutes before
removing
fuel cap. Loosen cap
slowly
to
relieve pressure in tank.
Fill or drain fuel tank outdoors.
DO NOT overfill tank. Allow space for fuel
expansion.
Keep
fuel away from
sparks,
open
flames,
pilot lights,
heat,
and other
ignition
sources.
DO NOT
light a
cigarette or smoke.
1.
Use clean, fresh, regular UNLEADED gasoline
with a minimum of 85 octane with equipment. DO
NOT use fuel which contains Methanol. DO NOT
mix oil with fuel. DO NOT use fuel that contains
more than 15% alcohol.
2.
Clean area around fuel fill cap, remove cap.
3.
Slowly add regular unleaded fuel to fuel tank. Be
careful not to overfill. Allow about 1.5" of tank
space for fuel expansion, as shown here.
4.
Install fuel cap and wait for any spilled fuel to
evaporate.
CAUTION!
Alcohol-blended
fuels (called gasohol,
ethanol or methanol) can attract moisture, which leads
to separation and formation of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage.
To avoid engine problems, the fuel system should be
treated with a fuel preserver or emptied before storage
of 30 days or longer. If adding a fuel preserver, fill the
fuel tank with fresh fuel. If only partially filled, air in the
tank will promote fuel deterioration during storage. If
fuel preserver is not used, drain the fuel tank, start the
engine and let it run until the fuel lines and carburetor
are empty. Use fresh fuel next season. See "Storage" on
pages 20-21 for additional information.
NEVER use engine or carburetor cleaner products in
the fuel tank as permanent damage may occur.
Fresh Start
TM
Fuel Cap
Adding fuel preserver helps keep fuel fresh and
carburetors clean for easier starting, all season long.
This new fuel cap automatically
drips concentrated fuel
3reserver into your fuel tank.
DANGER
* If SWALLOWED,
call physician
immediately.
, In case of emergency,
contact
a physician
immediately
and call 1-800-424-9300
for material
safety
information.
**Fuel stabilizer contains: 2,6-di-tret-butylphenol (128-39-2) and aliphatic
petroleum distillate (64742-47-8)
1.
Place cartridge into fuel cap.
Publicidad
Tabla de contenido
