Hilti SJD 6-A22 Manual De Instrucciones Original página 13

• The lockbutton can be seen only on the left: Transport position (the tool cannot start)
The on/off switch is locked and cannot be pressed.
• The lockbutton can be seen only on the right: After the tool has been switched on (on/off switch fully
pressed), the lockbutton can be pushed to the right to lock the switch in the "on" position. To release the
lock, press the on/off button again.
3.9 Anti-splinter insert
The product can be equipped with an anti-splinter insert.
The anti-splinter insert helps prevent splintering on the surface of wood materials when cutting.
3.10 Automatic switch-off
If the on/off switch is pressed continuously for longer than 15 minutes (e.g. during transport or storage), the
tool switches itself off automatically. This prevents deep discharge of the battery.
3.11 SJD DRS-6A dust removal module (accessory)
The SJD DRS­6A dust removal module is an accessory for the Hilti SJD 6-A22 orbital-action jig saw.
It collects a high percentage of the dust generated and can be quickly and easily attached to the orbital-
action jig saw. The dust removal module is equipped with a suction fan. This fan is driven by its own motor.
When the orbital-action jig saw is switched on the dust removal module draws its electric power from the
power tool's battery. The dust removal module is not suitable for working on materials containing asbestos,
metal dust and glass- or carbon-fiber dust. Use of the dust removal module to pick up damp or explosive
dust, chips or shavings is not permissible.
3.12 Items supplied
Orbital-action jig saw with saw blade, guard, dust removal adapter, anti-splinter insert, operating instructions,
hex key.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
4 Orbital-action jig saw
Rated voltage
Weight including B22⁄8.0 battery
Stroke length
Stroke rate under no load (n
Maximum cutting performance in wood
Maximum cutting performance in aluminium
Maximum cutting performance in unalloyed steel
Cutting angle (left/right)
Suction adapter outside diameter
Storage temperature
Ambient temperature for operation
Battery charging starting temperature
*2150254*
)
0
2150254
SJD 6-A22
21.6 V
7.1 lb
(3.2 kg)
1.1 in
(28 mm)
75 /min ... 3,000 /min
5.9 in
(150 mm)
1.0 in
(25 mm)
0.4 in
(10 mm)
0° ... 45°
1.08 in
(27.5 mm)
−4 ℉ ... 158 ℉
(−20 ℃ ... 70 ℃)
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
14 ℉ ... 113 ℉
(−10 ℃ ... 45 ℃)
English 7