Accessories - Ryobi HPL52 Manual Del Operador

REPLACING BLADES
See Figures 12 - 14, page 13.
The planer blades are reversible. When one edge becomes
dull, the blade can be reversed so that the other side can
be used.
Always replace or reverse blades in pairs. Do not attempt
to sharpen blades. If the blades in the planer show signs of
becoming dull, chipped, or damaged in any way, replace them.
When replacing the blades, use recommended replacement
blade only, RYOBI part number 039821001057.
WARNING:
Always wear heavy leather gloves and use caution when
loosening blade screws and handling and/or changing
blades. Blades are sharp and can cause serous personal
injury.
 Unplug the planer.
 Secure the planer in an upside-down position.
 Loosen the three screws securing the blade on the blade
holder by turning counterclockwise with the provided
blade wrench.
NOTE: Do not over-loosen the screws. If screws are too
loose, alignment of the new blade will not be accurate.
NOTE: Before removing the old blades, take notice of
the direction of cut as well as how the tapered edge of
the old blades are oriented. The tapered edge of the new
blades must be in the same orientation as the original
blades, with the tapered edge on the same side as the
screw heads and the flat edge facing the cutter block.
 Depress the spring-loaded blade guard.
 Push the blade holder out of the cutter block assembly
using the tip of a screwdriver.
 Remove the old blade from the blade holder by sliding
the blade out.
Look for these accessories where you purchased this product or call 1-800-525-2579.
Planer Blades ...................................................................................................................................................039821001057
Belt ...................................................................................................................................................................039821001042
NOTE: ILLUSTRATIONS START ON PAGE 11
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
MAINTENANCE
NOTE: If blade cannot be easily pushed out of blade
holder after loosening blade securing screws, use a
block of wood to break the blade loose from the blade
holder with a short sharp blow. Then push the blade with
a screwdriver to remove. If necessary, tap the block of
wood sharply with a small hammer to break the blade
loose.
 Clean any sawdust or wood chips from around the blade
area.
 Slide the new blade into the slot of the blade holder.
 Use a screwdriver to push the blade into the blade holder
until it is centered into position.
 Depress the spring-loaded blade guard.
 Insert the blade holder into the cutter block assembly.
 Retighten the three blade securing screws using the blade
wrench.
 Repeat the above procedure to change the other blade.
REPLACING THE BELT
See Figures 15 - 16, page 13.
When replacing the belt, use the recommended replacement
belt only, RYOBI part number 039821001042.
 Unplug the planer.
 Remove belt cover screws.
 Remove the belt cover.
 Force the old belt from the small pulley by turning in the
direction shown. As you turn the belt, pull and work it
off the small pulley until it has been completely removed
from both pulleys.
 Install the new belt over the large pulley. As you turn the
belt, push and work it onto the small pulley until it is in
place.
 Replace the belt cover.
 Install belt cover screws and tighten securely.
NOTE: Do not overtighten the screws.

ACCESSORIES

10 - English