Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
VP 9500
1. Boiler switch on/off O/1
2. Removable water tank
3. Power supply cable
4. Cable steam iron/boiler
5. Steam control knob
6. Steam ready indicator light orange
7. Green light for the water level/water reservoir presence
8. Indicator thermostat temperature setting plate
9. Iron temperature light.
10. Steam button lock option with continuous steam
11. Thermostat setting temperature iron plate
12. Iron switch on/off O/1
13. Cork handle
14. Flap filling water tank
15. Water filter
PREPARATION FOR USE
1. Place the unit on a stable, flat and heat-resistant surface.
2. Remove the water tank from its handle.
3. Fill the water tank with distilled water without exceeding the maximum level.
4. Assembled the water tank.
NOTE: If you do not want to fill the tank up to the max level, be sure to fill it up to at least to
the min level. Otherwise the unit will not deliver any steam
OPERATION AND CONTROL PANEL DETAIL
1.
Connect the power cord to the electrical outlet
2.
Press both red switches (AD) placed to the right and to the left of the control panel
3.
If you want to iron with the sole function iron, just turn on the switch (A) to the left
4.
The green indicator light (C) will illuminate at the same time the boiler power switch (A),
the iron is hot within a minute and a half
5.
If the green light remains off it means you have to fill the tank (low water), or that has not
been replaced properly.
6.
The orange light (B), immediately after the ignition is switched off, will turn on in less than
two minutes (Max level of water in the tank) to indicate that the device is ready to release
steam.
•
At the time of the first lighting there may be a slight emanation of smoke and smell
that is not harmful, and this phenomenon is normal, it will not affect the use of the unit
and will disappear in a short time.
• After about a minute, and regularly during use, the electric pump of the device sends
the water into the boiler. This causes a noise (bubbling) that is normal
7.
Adjust the emission of steam through the knob (E). The provision increases clockwise and
decreases by turning counter clockwise
8.
To emit steam press the button in front of the cork handle, and if you release your finger
dispensing stops, if you want to choose the "continuous steam" press the lock button located
at the center of the steam button.
13
Publicidad
Tabla de contenido
