Publicidad
Idiomas disponibles
Idiomas disponibles
Display
6.5. Maximum and minimum temperature values
The base station automatically stores the maximum and minimum outdoor/indoor
temperature.
• In temperature mode, repeatedly press the mem. button (19) to switch between the
current temperature, minimum temperature (MIN) and maximum temperature (MAX).
• Press and hold the mem. button (19) for approx. 3 seconds to reset the stored maximum
and minimum values.
6.6. Outdoor temperature alarm
• Repeatedly press the channel button (18) to select the measuring station channel (4) for
which you would like to set an alarm.
• In temperature mode, repeatedly press the alarm button (17) to display the outdoor
temperature alarms
• Press and hold the alarm button (17) for approx. 3 seconds until the outdoor temperature
display (12) begins to flash.
• Press the
button (14) or the
your selection by pressing the alarm button (17).
• While the upper
button (15) to select the temperature value or OFF and then press the alarm button to
confirm the selection (17).
Select the temperature value/OFF to activate/deactivate the outdoor temperature alarm.
• The alarm is triggered accordingly if the outdoor temperature reaches one of these limit
values.
The symbol and the outdoor temperature start to flash and an alarm signal sounds.
Press the alarm button (17) to stop the alarm. Otherwise, it will stop automatically after
2 minutes.
/
.
button (15) to set the displayed limit value and confirm
or lower
limit values are displayed, press the
Trend
Increasing
Constant
Decreasing
button (14) or the
13
Publicidad
