Troubleshooting - Cub Cadet CC350 Manual Del Operador

PROBLEM
THE ENGINE WILL NOT START
The fuel tank is empty
The primer bulb was not pressed enough
The fuel is old (over 30 days)
The spark plug is fouled
The engine is hot
THE ENGINE WILL NOT IDLE
The air filter is dirty
The fuel is old (over 30 days)
The idle speed is incorrect
THE ENGINE WILL NOT ACCELERATE
The fuel is old (over 30 days)
The cutting head is bound with grass
The air filter is dirty
THE ENGINE LACKS POWER OR STALLS
The fuel is old (over 30 days)
The air filter is dirty
The spark plug is fouled
THE CUTTING HEAD WILL NOT ADVANCE LINE
The cutting head is bound with grass
The cutting head is out of line
The inner reel is bound up
The cutting head is dirty
The line is welded
The line is twisted
Not enough line is extended
THE CUTTING LINE ADVANCES UNCONTROLLABLY
There is oil, cleaner or lubricant in the cutting head

TROUBLESHOOTING

If further assistance is required, contact an authorized service dealer.
SOLUTION
Fill the fuel tank with fresh fuel
Press the primer bulb 10 times
Drain the fuel tank and add fresh fuel
Replace the spark plug
Refer to the IF THE ENGINE IS HOT instructions in the Starting and
Stopping section
Clean or replace the air filter
Drain the fuel tank and add fresh fuel
Adjust the idle speed
Drain the fuel tank and add fresh fuel
Stop the engine and clean the cutting head
Clean or replace the air filter
Drain the fuel tank and add fresh fuel
Clean or replace the air filter
Replace the spark plug
Stop the engine and clean the cutting head
Refill the cutting head with new line
Rewind the line
Clean the inner reel and outer spool
Open the cutting head and remove the welded section
Rewind the line
Stop the unit, push the bump knob and pull the line until 4 inches
(102 mm) is outside of the cutting head
Clean and thoroughly dry the cutting head
17