Freeman FS4ATI Manual Del Usuario página 5

MODEL: FS4ATI
OPERATION
INFLATING / DEFLATING
1. Connect the tool to the air source.
2. Remove the tire's dust cap.
3. Depress the air chuck clip. Then press onto the tire
valve stem firmly and release the chuck clip once
the chuck is attached. Ensure there is no air
leaking.
4. Press the trigger untill resistance is felt to deflate
the tire. Press the trigger down fully to inflate the
tire.
5. Once the pressure gauge reaches the desired
pressure remove the air chuck from the tire valve.
Deflate Inflate
08
HTTP://WWW.FREEMANTOOLS.COM
USER NOTES
1. The inflator needs an air source to inflate. It
CANNOT inflate by itself.
MAINTENANCE
WARNING:
Disconnect the tool from the air source
before performing any maintenance on
the tool.
CLEANING
Clean the entire tool with a cotton rag after each use.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and maybe damaged by
their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
1-888-669-5672
MODEL: FS4ATI
WARNING:
Do not let brake fluids, gasoline,
petroleum-based products, penetrating
oils, etc. come in contact with plastic
parts. Chemicals can damage, weaken
or destroy plastic which may result in
serious personal injury.
WARNING:
Do not connect with an air compressor
that can potentially exceed the
maximum recommended air pressure.
The tool may burst, possibly causing
injury.
HTTP://WWW.FREEMANTOOLS.COM
09
1-888-669-5672