Intended Use; Preparation; Mounting And Connecting; 5�1 Preparation - Goobay SPW IT 2000 Instrucciones De Uso

User Manual
3

Intended Use

We do not permit using the device in other ways like described in
chapter „Description and Function" or in the „Safety Instructions"� Use
the product only in dry interior rooms� Not attending to these
EN
regulations and safety instructions might cause fatal accidents, injuries,
and damages to persons and property�
4

Preparation

1� Check the scope of delivery for completeness and integrity�
2� Compare the specifications of all used devices and ensure compatibility.
5

Mounting and Connecting

5.1 Preparation
1� Check the battery terminals before connecting�
2� You must NOT use the voltage transformer with the vehicle if the positive
pole „+" is connected to a metallic part of the vehicle�
3� Use the battery cable with ring terminals for connecting to the vehicle bat-
tery�
The vehicle battery discharges when the vehicle is not in operation.
5.2 Mounting
Mount the voltage converter with suitable screws in the vehicle interior
○ on stable and leveled places,
○ on clean, dry and nonflammable surfaces,
○ in well-ventilated areas�
Mounting screws are not included.
5.3 Connecting to the vehicle battery
• DO NOT connect USB devices to the vehicle in parallel via another inter-
face!
• Never place the voltage converter near flammable materials or in places
where flammable gases can develop.
• Make sure that the voltage converter is switched off before you start con-
necting�
• Ensure that the polarity is correct�
For optimum operation, we recommend using a battery with > 200 Ah.
1� Loosen the terminal screws of the plus and minus pole at the rear side of
the voltage converter�
2� Put the red battery cable (10) straighht in the DC-input „+" (2) and tighten
the terminal screw�
3� Put the black battery cable (10) in the DC-input „-" (4) and tighten the black
terminal screw�
4� Connect the red battery cable (10) with the eyelet to the positive terminal
of the battery�
This is red or marked with „P" or „+".
15
Ground short circuit and fire hazard