Cleaning And Maintenance - Bestron AYT600 Manual Del Usuario

operAtion
- General
The appliance is intended only for domestic use,
not for professional use.
1. Crumb tray
2. Housing
3. Stop button
4. Temperature-control dial
5. Roll holder button
6. Power cord and plug
7. Lever
8. Bread carriages
9. Roll holder
before first use
Operate the toaster a couple of times, without bread, at the maximum temperature (setting 5). This will
remove the last traces from the manufacturing process. A little smoke and odour may be emitted by the
toaster when it is used for the first time.
use
1. Put the appliance on a stable and flat surface.
2. Put the plug into the wall socket.
use -
toasting bread
1. Adjust the temperature and the toasting time with the temperature-control dial. (4)
a. The temperature is lowest at setting 1, and the toasting time is the shortest.
b. The temperature is highest at setting 5, and the toasting time is the longest.
c. In the event of doubt, always begin at a lower setting.
d. Older bread will need to be toasted at a lower setting than fresh bread.
e. Brown bread will need to be toasted at a higher setting than white bread.
2. Put one slice of bread on each of the toaster's bread carriages. (8)
3. Lower the slices of bread by pressing the lever (6) downwards until it locks into place. The appliance
will now start toasting the bread; it will automatically switch off once the toast is ready. The slices of
toast will rise automatically.
4. Remove the toast from the toaster.
• The bread will emit smoke if the temperature is adjusted to too high a setting. If this happens,
press the stop button (3) to stop toasting the bread.
• If toast remains caught in the toaster, then you should remove the plug (6) from the wall socket and
allow the toaster to cool. You can now carefully remove the toast from the toaster.
use -
heating rolls or french bread
1. Lay the rolls or the French bread on the roll holder. (9)
2. Use the same procedure as for toasting bread, but without putting slices of bread on the bread
carriages.

cleAninG And MAintenAnce

1. Remove the plug from the wall socket, and allow the appliance to
cool.
2. Take the crumb tray (1) out of the appliance (see Figure 3) , and
remove any breadcrumbs.
3. Clean the exterior (2) of the appliance with a damp cloth, and dry with
a clean cloth. Make sure no moisture gets into the appliance.
4. Slide the crumb tray back into the appliance.
8
2
6
1
Figuur 3
16
user's instructions
9
5
7
4
Figure 1
3