BLACK&DECKER TM500 Manual De Instrucciones página 11

Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by hand or against your body leaves it unstable
and may lead to loss of control.
Before drilling into walls, floors or ceilings check for the
location of wiring and pipes.
Avoid touching the tip of a drill bit just after drilling, as it
may be hot.
Features
This tool includes some or all of the following features:
1. On/off switch
2. Lock-on button
3. Drilling mode selector
4. Chuck
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting a drill bit or screwdriver bit
Keyed chuck (fig. A)
Open the chuck by turning the sleeve (5) counterclockwise.
Insert the bit shaft (6) into the chuck.
Insert the chuck key (7) into each hole (8) in the side of
the chuck and turn clockwise until tight.
Removing and refitting the chuck (fig. B)
Open the chuck as far as possible.
Remove the chuck retaining screw, located in the chuck,
by turning it clockwise using a screwdriver.
Tighten an Allen key into the chuck and strike it with
a hammer as shown.
Remove the Allen key.
Remove the chuck by turning it counterclockwise.
To refit the chuck, screw it onto the spindle and secure it
with the chuck retaining screw.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Before drilling into walls, floors or ceilings, check for
the location of wiring and pipes.
Selecting the direction of rotation (Applicable for TM505)
For drilling and for tightening screws, use forward (clockwise)
rotation. For loosening screws or removing a jammed drill bit,
use reverse (counterclockwise) rotation.
To select forward rotation, push the forward/reverse
slider to the centre position.
To select reverse rotation, push the forward/reverse slider
to the left.
Warning! Never change the direction of rotation while the
motor is running.
Selecting the drilling mode
For drilling in masonry, set the drilling mode selector (3) to
the position.
For drilling in other materials and for screwdriving, set the
drilling mode selector to the position.
Switching on and off
To switch the tool on, press switch (1). For variable speed
units, the tool's speed depends on how far you press the switch.
As a general rule for variable speed units, use low speeds
for large diameter drill bits and high speeds for smaller
diameter drill bits.
For continuous operation, press the lock-on button (2) and
release the switch. This option is available
only at full speed. This option does not work in reverse
rotation.
To switch the tool off, release the switch. To switch the tool
off when in continuous operation, press the switch once
more and release it.
Accessories
The performance of your tool depends on the accessory used.
Black & Decker accessories are engineered to high quality
standards and designed to enhance the performance of
your tool. By using these accessories you will get the very
best from your tool.
Maintenance
Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance, switch off and
unplug the tool.
Regularly clean the ventilation slots in your tool using a
soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Service
Black & Decker offers a full network of company-owned and
authorized service locations. All Black & Decker Service
Centers are staffed with trained personnel to provide customers
with efficient and reliable power tool service. Whether you
need technical advice, repair, or genuine factory replacement
parts, contact the Black & Decker location nearest you.
ENGLISH
11