Dynex DX-WEGRTR Guia Del Usuario página 7

Product features
# Component
3 Security Sync button Push and hold this button for three seconds, then initiate the Security Sync (WPS)
4 Security Sync LED
4 Wireless network LED Off—The wireless network is off
5 Internet LED
6 Modem status LED
7 Wired computer
status LEDs
procedure on the client device within two minutes. Your client will automatically
exchange the security information and be added to your wireless network. Pushing
the Security Sync button will automatically enable WPS. See "Using Security Sync
(Wi-Fi Protected Setup)" on page 28.
Lights to indicate that WPS has been activated.
Blinking Green—The router is searching for a WPS client to connect with.
Solid Green—The secure connection has been established with the client.
Solid Green—The wireless network is ready
Blinking Green—Network activity
This unique LED shows you when the router is connected to the Internet. When the
light is OFF, the router is not connected to the Internet. When the light is blinking,
the router is attempting to connect to the Internet. When the light is solid green, the
router is connected to the Internet. When using the "Disconnect after x minutes"
feature, this LED becomes extremely useful in monitoring the status of your router's
connection.
Off—Router is not connected to the Internet
Blinking Green—Router is attempting to connect to the Internet
Solid Green—Router is connected to the Internet
This LED lights green to indicate that your modem is connected properly to the
router. It blinks rapidly when information is being sent over the port between the
router and the modem.
Off—No WAN link
Solid Green—Good WAN link
Blinking Green—WAN activity
These LEDs are labeled 1-4 and correspond to the numbered ports on the rear of the
router. When a computer is properly connected to one of the wired computer ports
on the rear of the router, the LED will light. green means a 10Base-T device is
connected, orange means a 100Base-T device is connected. When information is
being sent over the port, the LED blinks rapidly.
Off—The wireless network is off
Solid Green—A 10base-T device is connected
Solid Orange—A 100base-T device is connected
Blinking—Port activity
Description
7