Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
The guard release lever should snap into one of the
alignment holes
17
on the guard collar. This ensures
that the guard is secure.
5. To remove the guard, follow steps 1–3 of these
instructions in reverse.
Fig. G
15
16
Flanges and Wheels
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Mounting Non-Hubbed Wheels (Fig. H)
WARNING: Failure to properly seat the flange/ clamp
nut/ wheel could result in serious injury (or damage to
the tool or wheel). "
CAUTION: Included flanges must be used with
depressed center Type 27 grinding wheels and
Type 1/41 and Type 27/42 cutting wheels. See the
Accessories Chart for more information.
WARNING: A closed, two-sided cutting wheel guard
is re quired when using cutting wheels.
Cutting wheels include diamond wheels and abrasive
discs. Abrasive cutting wheels for metal and concrete
use are available. Diamond blades for concrete cutting
can also be used.
CAUTION: Included flanges must be used with
all non-hubbed accessories except conventional
sanding discs.
WARNING: Use of a damaged flange or guard or
failure to use proper flange and guard can re sult in
injury due to wheel breakage and wheel contact. See
the Accessories Chart for more information.
1. Install the unthreaded backing flange
with the raised section (pilot) facing the wheel
as shown.
2. Place wheel against the backing flange, centering the
wheel on the raised section (pilot) of the backing flange.
3. While depressing the spindle lock button and with the
hex depressions facing away from the wheel, thread the
locking flange
8
on spindle so that the lugs engage the
two slots in the spindle.
12
4. While depressing the spindle lock button, tighten the
locking flange with a wrench.
5. To remove the wheel, depress the spindle lock button
and loosen the threaded locking flange with a wrench.
17
10
Mounting Sanding Backing Pads
(Fig. A, I)
nOTE: Use of a guard with sanding discs that use backing
pads, often called fiber resin discs, is not required. Since a
guard is not required for these accessories, the guard may or
may not fit correctly if used.
1. Remove the inner flange.
2. Place or appropriately thread backing pad
the spindle.
3. Place the sanding disc
4. While depressing spindle lock
on spindle, piloting the raised hub on the clamp nut
into the center of san ding disc and backing pad.
on spindle
7
4
5. Tighten the clamp nut by hand. Then depress the
spindle lock button while turning the sanding disc until
the sanding disc and clamp nut are snug.
Fig. H
WARNING: Failure to properly seat the flange/ clamp
nut/ wheel could result in serious injury (or damage to
the tool or wheel).
WARNING: Proper guard must be reinstalled for
grinding wheel, cutting wheel, sanding flap disc,
wire brush or wire wheel applications after sanding
applications are complete.
19
on the backing pad
3
Fig. I
8
6
7
4
18
on
18
.
, thread clamp nut
20
20
19
18
Publicidad
Tabla de contenido
