[.,,."_o,,_
V_I Z IB]P'_"_
11. Remove the three fasteners
that
hold the friction
wheel to the hub
(see Figure 43).
12. Remove the friction
wheel from the
hub. Slip the friction
wheel off the
hex shaft,
13. Assemble the new friction
wheel
onto hub with the fasteners re-
moved earlier.
14. Install the hex shaft and bearings
with the four bolts removed earlier
(see Figure 44).
Make sure the washers are prop-
erly installed in the original posi-
tion. Also, make sure the two
washers are properly aligned
with the actuator arms.
15. Make sure the hex shaft turns free-
ly.
16. Install the left wheel, axle, and
drive sprocket
with the fasteners
removed earlier. Install the chain
onto the drive sprocket
(see
Figure 41).
17. Check the adjustment of the friction
wheel. See "How To Adjust The
Friction Wheel" in this section.
18. Make sure the friction wheel and the
disc drive plate are free from grease
or oil.
19. Install the bottom
panel (see
Figure 40).
20. Tighten the bolts on each side of
the bottom panel.
21. Install the right wheel to the axle
with the fasteners removed earlier.
22. Connect the spark plug wire.
Friction
Fasteners
_,
Hub Wheel
Hex Shaft
Fasteners
Figure 43
F 0410109L
Actuator Arms
Bearings
\
Washer
31
//_Washer
Bearings
/
Washer
I /
Washer
Figure 44