Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: I fthecables h ave become dis-
connected,
connect cables a sshown i n
Figure 7 .
Traction Drive Cable Auger Drive Cable
Figure 7
HOW TO ASSEMBLE
THE CHUTE DEFLECTOR
1. Remove the carriage
bolt. See
Figure 8.
2. Raise the chute deflector
into op-
erating
position.
3. Fasten chute deflector
to flange
with carriage bolt. Make sure to
install with head of carriage
bolt on
the inside of the flange.
4. Fasten with washer and Iocknut.
5. Tighten Iocknut
securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
eflector
Nut
/_:_/_
_ Ope_-ating_
Position
@up.(
_
/,fP-_n
!
Walsh_,r_
_
..... !.
_FlanOa_ riage B°lt
Figure 8
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing.
To adjust the skid
height for different conditions, see To
Adjust Skid Height paragraph in the
Service And Adjustment
section.
HOW TO SET THE LENGTH
OF THE CABLES
The cables were adjusted at the factory
be too tight or too loose. If an adjust-
and no adjustments should be neces-
ment is necessary, see "How To Check
sary. However, after the handles are put
And Adjust The Cables" in the Service
in the operating position, the cables can
And Adjustment section.
F 0410109L
9
Publicidad
