Replacing The Fuse; Cleaning And Maintenance - Black+Decker BFT114 Manual De Instrucciones

ENGLISH
SET UP & USE
OPERATION OF YOUR FAN
Take out the fan from the packing carton. Turn the fan upright and it is now ready
for use.
USING YOUR FAN
To turn the fan ON, turn the control knob left to select fan speeds or right to select
fan speeds with oscillation functions.
• Turn the Control Knob left to select the fan speed
I (Low Speed).
• Turn the Control Knob right to select a fan speed with oscillation
function II (High Speed) or I (Low Speed).
• Turn the Control Knob to O (OFF) to shut off the unit.
Page 6 Page 6
II (High Speed) or
SET UP & USE

REPLACING THE FUSE

• Disconnect fan from power outlet by grabbing the plug at the end of the cord. Do
not unplug by pulling the cord itself
• Open fuse cover located in the side of the power cord plug by sliding it toward the
plug blades
• Remove fuse carefully by taking a small tool and slowly prying out one end. Once
you have one end out, slowly pry out the other end.
• To avoid the risk of fire, replace only with similar 2.5 Amp, 125V fuse.
• Close fuse cover by sliding cover toward the top of the plug.
CAUTION: Do not attempt to replace the plug itself. Discard the product entirely if
the plug itself is damaged.
Fuse
Fuse cover

CLEANING AND MAINTENANCE

WARNING: Be sure to unplug from the electrical supply source before cleaning.
Be sure not to get water or any other liquid inside the motor.
Do not disassemble the fan for cleaning.
• Plastic parts of the fan should be cleaned with mild soap and a damp cloth or
sponge. Rinse with clean water to remove any soapy film residue.
ENGLISH
Page 7 Page 7