Truper LIOR-1/4A2 Manual De Instrucciones página 19

Start up
This sander is designed to sand wood, metal, plastic and similar materials. Can be used for repetitive sanding and fine finish.
Its size is ideal for final jobs.
Dust extraction
• Before connecting the tool to the power source, adjust
the dust-collecting container onto the extraction duct in the
back of the sander.
• For a better dust collection remove and empty the
container when full to the middle.
• Use the container when sanding wood. Do not use it to
sand metal. Hot metal particles could ignite wood dust
residues or the inner bag.
• A vacuum cleaner adaptor (not included) can also be
used instead of the collecting container to connect the
sander to a vacuum.
• Clean regularly the dust layers existing in the base,
underneath the sanding sheet.
Sander operation
• Turn on the sander before setting it on the work piece.
• Keep the sander base parallel to the work piece surface.
• Press down onto the work piece making circular
movements and verifying the entire sander base is
supported on the work piece.
• Use moderate pressure. Do not force the sander. Run in
at a moderate speed. Overheating may occur if too much
pressure is applied. The motor will run slow leading to
inefficient sanding and damage to the motor.
Aditional tips
• If marks on the surface persist after sanding, sand again
with a coarser grit to remove them; change the sandpaper
with the previous one and finish the sanding. Or change
the worn sandpaper with a new one.
• Do not let the sandpaper wear completely, you must
replace it before.
7
ENGLISH