Start Up - Truper LIOR-1/4A2 Manual De Instrucciones

Selecting the sandpaper
• Select the right sander sheet grain.
• Grains available vary from very coarse to very fine.
• Coarse grain is used to sand rough surfaces, medium grain for
light work and fine, for finishing purposes.
• Is advisable to test with disposable pieces to determine the
right grain for each particular job.
• Do not use the same sheet to sand wood or metal. Metal
particles may embed into the sander and damage the wood
surface.
Installing the sand paper
• Release the sandpaper clamps on both sides of the sander.
• Set the narrow side of the sandpaper under one of the clamps and
pull so it stays uniformly onto the base.
• Verify the orifices match those in the base. Then adjust the other side.
• In case the sandpaper installed does not have the corresponding
orifices, punch the holes with the hole-puncher included. Make the
sander base even and apply pressure downwards until the sheet is
punched.
• The sheet must be perfectly fastened; otherwise there could be
excessive wear in the base.
CAUTION
Do not keep on using the tool if the sandpaper is
worn or damaged.
Turning On
• Connect the plug into the power outlet.
• To turn on the tool, press switch (A), to the left.
• To turn off the tool, press the switch into the opposite side.
Do not turn on the tool when the sandpaper surface
CAUTION
is onto the work piece.
CAUTION Before turning off the tool move it away from the
work piece.
6
ENGLISH

Start up

Grain Type
60 or lower very coarse
80 - 100 coarse
120 - 150 medium
180 - 220 fine
240 or higher very fine
• To get the 1/4 sandpaper size compatible with the
sander, fold the commercial size sheet (A-4) twice
down the middle. You get four 4,25" x 5,5" sheets.
A